Power Tool Manufacturers · Recalled
CPSC, Power Tool Manufacturers Announce Recall of Electric Drills
The switches on these power tools, which were manufactured by Eaton Corp., of Cleveland, Ohio, can stick. The drills can continue to operate after the trigger is released, posing a risk of injury to consumers.
- Units
- About 58,000
- Reports
- 4
- Injuries
- 1
- Deaths
- —
- Price
- $300–$555
- Remedy
- See notice
Reports, injuries, deaths and price are read out of the notice’s wording by rules, so they can miss unusual phrasing. The official notice is the record.
Affected
The drills were sold under the brand names, Milwaukee Electric Tool 1/2" drills and DEWALT 1/2" Stud & Joist Drills. The following chart lists the 1/2" drills included in this recall: Tool Manufacturer Model Numbers of Recalled Tools Serial Numbers or Date Codes of Recalled Tools Recall Hotline Number Milwaukee Electric Tool Corp. 1610-1 1630-1 1670-1 1675-1 Serial Numbers: 700B400200013 to 700B400480097 718B400230057 to 718B400480118 472B400200061 to 472B400440188 413B400190567 to 413B400522000 (866) 473-2288 8 a.m. to 4:30 p.m. CT Monday through Friday DEWALT Industrial Tool Co. DW124 or DW124K Date Codes: 0021 through 0110 (800) 433-9258 8 a.m. to 5 p.m. ET Monday through Saturday The model number and serial number/date code are written on an identification plate attached to the drill or stamped into the drill body.
The file
- Sold at
- Home center and hardware stores, industrial tool distributors, and factory service dealers sold these drills with the Eaton switches nationwide, from May 2000 to April 2001, for between $300 and $555.
- Product type
- Drills & Bits
- Made in
- Not stated
- Recalled by
- DEWALT Industrial Tool Co., of Baltimore, Md., Eaton Corp., of Cleveland, Ohio, Milwaukee Electric Tool Corp., of Brookfield, Wis.
Incident log
Milwaukee Electric Tool Corp. has received four reports of drill switches sticking in the on position and one report of a hand injury. DEWALT has received three reports of drill switches sticking in the on position but no reported injuries.
What the notice says to do
Consumers should stop using these drills immediately and contact the tool manufacturer to receive a free tool repair.
Milwaukee Electric Tool Corp.: (866) 473-2288, 8 a.m. to 4:30 p.m. CT, DEWALT Industrial Tool Co.: (800) 433-9258, 8 a.m. to 5 p.m. ET
Recall notice published by the U.S. Consumer Product Safety Commission. This site is independent: always confirm on the official notice before acting.
Notice first dated MAY 10 2001; last revised FEB 25 2026.
