Lite Machines Corp. · Recalled
CPSC, Lite Machines Corp. Announce Recall of Motor Speed Controller
The Fusion 35 motor speed controller may not operate properly, due to a weakness in a batch of integrated circuit (IC) chips. The (IC) chip can become hot and damage the controller. In certain instances, a malfunctioning IC chip can cause the helicopter motor to turn on for the several seconds before the power is disconnected, which can damage the helicopter or cause injury to the operator or bystanders.
- Units
- 375
- Reports
- 3
- Injuries
- —
- Deaths
- 0
- Price
- $60
- Remedy
- See notice
Reports, injuries, deaths and price are read out of the notice’s wording by rules, so they can miss unusual phrasing. The official notice is the record.
Affected
The Fusion 35 speed controller, a small printed circuit board with wires extending from either side, is packed in a clear plastic bag separate from other radio system components, and carries the identification "Fusion 35 #30499" on its front plate.
The file
- Sold at
- These components were sold with the electric helicopter kits at hobby shops, from November 2001 through December 2001, for about $60.
- Product type
- Toy Helicopters
- Made in
- Not stated
- Recalled by
- Lite Machines Corporation, of West Lafayette, Ind.
Incident log
There were three incidents where the motor came on for several seconds and damaged the helicopter. There have been no injuries.
What the notice says to do
Consumers should send the Fusion 35 speed controller to Lite Machines for a diagnostic test by the manufacturer. If the unit is defective, it will be replaced free of charge.
For more information, contact Lite Machines at (765) 463-0959 between 9:00 a.m. and 5:30 p.m. CT Monday through Friday.
Recall notice published by the U.S. Consumer Product Safety Commission. This site is independent: always confirm on the official notice before acting.
Notice first dated DEC 31 2001; last revised OCT 28 2025.