Watts Water Technologies · Recalled
Watts Water Technologies Recalls Rotor and Shaft Assemblies Due to Fire Hazard
If the assembly was installed in a fire suppression system and remained in a closed position, sufficient water might not have been available in the event of a fire. This posed a fire hazard to consumers.
- Units
- About 15
- Reports
- —
- Injuries
- —
- Deaths
- 0
- Price
- $420
- Remedy
- See notice
Reports, injuries, deaths and price are read out of the notice’s wording by rules, so they can miss unusual phrasing. The official notice is the record.
Affected
The Rotor and Shaft Assembly was sold separately or as part of the model F10-13 Float Pilot. These components are used in certain fire suppression systems and domestic water supply applications.
The file
- Sold at
- Distributors and contractors from December 2007 through August 2008 for about $420.
- Product type
- Fire Suppressors
- Made in
- United States
- Recalled by
- Watts Water Technologies Inc., of North Andover, Mass.
Incident log
None reported.
What the notice says to do
Distributors, contractors and consumers with the recalled rotor and shaft assemblies were contacted directly and the affected units were replaced.
For more information, contact Watts at (800) 615-9394 between 8 a.m. and 5 p.m. CT Monday through Friday.
Recall notice published by the U.S. Consumer Product Safety Commission. This site is independent: always confirm on the official notice before acting.
Notice first dated NOV 20 2008; last revised MAY 23 2014.